« previous next »
Pages: [1]

Author Topic: Add the Wrench to the Rack!  (Read 3601 times)

MUCCI

  • Mudders
  • **
  • Posts: 462
Add the Wrench to the Rack!
« on: December 29, 2008, 01:01:45 PM »
Tightened the #2 Bolt on Thrill Hammer on Saturday, Which was very, very Loose!  I can't think how many times I needed a wrench and settled on "finger tight". 
*MUCCI*
Logged

mynameismud

  • unworthy
  • Posts: 5985
    • Mudncrud
Re: Add the Wrench to the Rack!
« Reply #1 on: December 29, 2008, 03:00:30 PM »
Is that bolt a stud type bolt?  If so I have some locktite.  Even if it is a Rawl it may be possible to pull the bolt locktite the end and put it back in. 
Logged
Here's to sweat in your eye

MUCCI

  • Mudders
  • **
  • Posts: 462
Re: Add the Wrench to the Rack!
« Reply #2 on: December 29, 2008, 03:27:33 PM »
3/8 stud probably a wedge, that bolt sees alot of work as that is the crux of the climb.  I have seen many people fall and hang there so the bolt could use a bit of spooge.  Also the nut is partially stripped so a new one might be in order (Pre-spooge) of course!
*MUCCI*
Logged

mynameismud

  • unworthy
  • Posts: 5985
    • Mudncrud
Re: Add the Wrench to the Rack!
« Reply #3 on: December 29, 2008, 04:13:46 PM »
Does not sound good.  Thank you for the info.  I will ask around and see about a glue in.  It is either that or a 1/2" bolt.

If that is a stud type bolt then it is most likely a wedge.  Not to many split shaft bolts out there,  a few but not many.
Logged
Here's to sweat in your eye
Pages: [1]
« previous next »